P0110 to P0114: intake air temperature sensor
The sensor that measures the temperature of the air coming into the engine has a circuit fault or an implausible reading. P0113 (signal high) is the one seen most.
SeverityLowLittle risk to the car, but the fault stays until it is repaired.
Can you keep driving?Safe to drive, book a checkWhat does P0113 mean?
The intake air temperature sensor lets the computer correct the fuel and ignition for air density: cold air is denser than hot air. It is usually a simple thermistor, often built into the air flow sensor. A signal stuck high normally means the circuit is open, which the computer reads as extremely cold air; stuck low means a short.
What causes P0113?
- A sensor left unplugged after an air filter change
- A broken wire or a corroded terminal
- A failed sensor, or a failed air flow sensor where it is built in
- A cracked connector housing that lets water in
What to check first for P0113
- Make sure the sensor or air flow sensor is plugged in fully
- Compare the reading on a scan tool with the outside temperature on a cold engine
- Check the terminals for corrosion and the wires for breaks
- Measure the sensor's resistance against the specification for its temperature
Can you drive with P0113?
Safe to drive. The engine may run slightly rich or hesitate in cold weather, and economy can drop, so have it fixed when convenient.
In states with an OBD-II emissions inspection, a car with the check engine light on fails the test until the fault is fixed.
Codes on this page
- P0110Intake Air Temperature Sensor 1 Circuit
- P0111Intake Air Temperature Sensor 1 Circuit Range/Performance
- P0112Intake Air Temperature Sensor 1 Circuit Low
- P0113Intake Air Temperature Sensor 1 Circuit High
- P0114Intake Air Temperature Sensor 1 Circuit Intermittent
Related codes
Checked on · Rafael Soares
These are the generic meanings every manufacturer shares. Each brand adds its own detail, so your car's handbook, its service information and a qualified mechanic have the last word. OdoKeep has no connection with any manufacturer, and the app does not read codes from the car.
